Aluminum mold construction site

category：

Aluminum alloy template

keyword：

wall

column

elevation.

Mark the wall column lines, wall column control lines, and opening lines on the floor, with the wall column control line 200mm away from the wall edge line, to check whether the template is offset and square; Mark the floor elevation control points on the longitudinal bars of the columns, and set them at the four corners and corners of the walls and columns to check the floor elevation.

Consultant：

+86-15922556636（Mr. Liu）

DESCRIPTION

Aluminum alloy formwork construction process:

1. Mark the wall column lines, wall column control lines, and opening lines on the floor, with the wall column control line 200mm away from the wall edge line, to check whether the template is offset and square; Mark the floor elevation control points on the longitudinal bars of the columns, and set them at the four corners and corners of the walls and columns to check the floor elevation.

2. Install wall and column reinforcement, pre embedded water and electricity boxes, conduit, reserved openings, etc. After completion, handle the concealed engineering acceptance procedures.

3. Install wall column formwork

Product consultant

Aluminum mold installation and construction