Solution
We have multiple standard aluminum template production lines and automatic production processes,
equipped with a fully functional template system and a professional research team
The aluminum alloy formwork system can be divided into two categories according to different stress modes: tension rod system and tension plate system.
Aluminum alloy templates are divided into standard templates and non-standard templates according to their common forms. The commonly used components that meet the requirements of a rectangular flat plate with a rib height of 65mm, a hole diameter of 16.5mm, a hole center distance of 40mm from the panel, and a length, width, and hole center distance that are multiples of 50mm, as well as corner templates and shapes, are all standard plates.
Aluminum mold accessories display
The accessory system mainly consists of bolts, dowels, screws, and pull tabs.
Aluminum mold accessories on-site
The accessory system mainly consists of bolts, dowels, screws, and pull tabs.
The system template includes door and window openings, structural slope making, one-time anti slope, water stop joint, bottom box pre embedded, and door head hanging plate;
Aluminum mold template installation
Mark the wall column lines, wall column control lines, and opening lines on the floor, with the wall column control line 200mm away from the wall edge line, to check whether the template is offset and square; Mark the floor elevation control points on the longitudinal bars of the columns, and set them at the four corners and corners of the walls and columns to check the floor elevation.
Aluminum mold installation and construction
The system template includes door and window openings, structural slope making, one-time anti slope, water stop joint, bottom box pre embedded, and door head hanging plate;
Aluminum mold construction site
Mark the wall column lines, wall column control lines, and opening lines on the floor, with the wall column control line 200mm away from the wall edge line, to check whether the template is offset and square; Mark the floor elevation control points on the longitudinal bars of the columns, and set them at the four corners and corners of the walls and columns to check the floor elevation.
